Features and Uses of Water Softener Resin

The resin is the key non-expandable element that turns hard water to soft. It takes away calcium and magnesium alloys from hard water. People who use electronic water softener resin beads regularly know that there are three steps involved in the process, which are the backwash, recharge and then rinsing. In all three steps in the process, resin is involved.

Three Steps in Using Water Softener Resin

Here are three steps involved in using water softener resin for hard water:

The treatment is initiated when hard water is allowed to flow into the mineral tank. As the hard water flows, sodium ions mix with hydrogen ions while calcium and magnesium ions usually adhere to the surface of the resin. The combination of hydrogen and sodium ions then replaces the calcium and magnesium ions.

The second stage is called recharge. This is the transferring of brine solution from its tank into a mineral tank. In this step, the sodium ions that originate from the brine are trapped by the resin. The removal of calcium and magnesium ions is continued in this step.

On the third stage, the ions that were trapped in the second phase are used.

Through time, the water softener resin cleaner will start losing its effectiveness due to more sodium ions being displaced by ions of calcium and magnesium. Creating the brine solution solves this problem. The brine tank and softener are connected to each other by means of a control valve that manages the recharging and flushing of the system. A drain line is also incorporated with the water softener, which allows minerals to be taken out of the softener, instead of through the faucets. If there is a need for a water softener resin replacement, there are many online sites that are offering the product.

Control Valves Used

There are a couple of control valves that can be used by a water softener resin system.

One valve can be programmed so that the system can be recharged at certain intervals. This system has the benefit of allowing the user to adjust the system accurately to a particular makeup of water.

This kind of valve recharges your system according to the amount of water, which has gone through the softener. Take note though that the actual volume of water that is processed by the softener at any particular time can greatly fluctuate. This causes the water softener resin to be overworked or the system to be flushed too early, thereby reducing the cost effectiveness and efficiency of the system.

The standard softener system is only designed to take out minerals that make water hard. It does not filter out sand and other debris. The system also does not remove nitrites or nitrates from the water. In addition, if you do not add an anion exchange media, no tannins could be removed from the water. The benefits of using the best water softener resin in a system could be seen on the greater effectiveness of shampoos and soaps. This is because the taking away of the minerals allow the products to work without adhering to water ions. Water softener resin will also eliminate hard water stains that stick to your sinks and tubs.
Contact us
Also find more information @ just-water-softeners.com